Sanpress Inox G

Flow-​optimized press connector system with press connectors and pipes made of stainless steel 1.4401. Press connectors for protecting the sealing element equipped with cylindrical pipe guide. Press connectors from d64.0 with stainless steel cutting ring to ensure the mechanical strength of the connection. For protection pipes are equipped with pipe plugs. The pressing force is located before and behind the sealing element seat.

Marking:

Manufacturer, pipe dimension, batch, yellow dot on press end, yellow rectangle with inscription »Gas MOP 5 / GT5« for Sanpress Inox G connectors, yellow rectangle with inscription »Gas MOP 5 / GT1« for Profipress G connectors made of gunmetal, yellow pipe plug, detachable orange label as press indicator from d64.0.

Press connector with SC‑Contur:

Inadvertently unpressed connections are noticed immediately during a leakage test. Viega guarantees the detection of unpressed connections in the following pressure ranges with compressed air or inert gases:

• Minimum air pressure: 22 hPa / 22 mbar / 0.3 PSI.
• Maximum air pressure: 0.3 MPa / 3 bar / 43.5 PSI.

Sealing elements:

HNBR (hydrogenated acrylonitrile butadiene rubber), yellow, pre-​assembled.

Tools:

The functional safety of Viega press connector systems depends primarily on the faultless condition of the press tools used. For the manufacture of press connections, Viega recommends the use of Viega press tools. Viega press tools have to be regularly maintained by authorized service partners.

Standards and approvals:

• Press connector system with press connectors and pipes in accordance with DIN EN 10088, DVGW Worksheet GW 541.
• Press connector approval for stainless steel in accordance with DG-8531BR0333.
• Press connector approval for gunmetal in accordance with DG-8531BP0069.
• Gases in accordance with DVGW G 260 in gas installations in accordance with DVGW-​TRGI 2018 (DVGW Worksheet G 600) / DVFG-​TRF 2012.
• Liquid gases in the gas phase for domestic and commercial applications, tested in accordance with DVGW Worksheet G 5614.
• Pipelines for heating oil in accordance with DIN 51603 and pipelines for diesel fuel as suction and pressure pipelines in accordance with DIN EN 590 in consideration of the General Building Approval Z-38.4‑1.